A handsaw for cutting PVC pipes? It doesn’t sound practicable, especially knowing that it can be draining or exhausting and takes a lot of time. If you are into DIY and desperately need to cut your PVC pipe so that it can fit properly, then a handsaw is the best tool that you can lay your hands on.
There are many methods of cutting a PVC pipe, but a handsaw beats all of them because they are usually within reach whenever someone wants to work with them. If you are trying to git in PVC pipes in your home, you are better off purchasing a handsaw.
A PVC pipe is made of plastic, so you need a sturdy metal that is sharp as well to cut it down. It isn’t exactly a hard job when you are using a handsaw. It takes time, and it can be exhausting, but the result is always worth it.
Handsaws are quite affordable. Unlike other types of saws like electric saws and hacksaws, handsaws are relatively cheaper and easier to get. You can get it in a local appliances store for a small amount of money, and this comes in handy if you are looking to cut off part of your pipe quickly.
It should be noted that it can get a little messy if you are working with a handsaw. Handsaws are manual equipment, and you might notice particles of your PVC pipe flying about everywhere. Ultimately, you will have so much to clean at the end of the day.
How to Use a Handsaw to Cut a Pvc Pipe
First of all, you want to put on your safety gear before attempting to cut your PVC pipe. Putting on a safety gear
You will also need to get gloves to protect your hands from being cut by mistake. People usually cut themselves when they are trying to go too fast with the handsaw. It would help if you had thick gloves that would prevent the handsaw from doing any severe damage to your hands.
When it is being cut, the particles from a PVC pipe can irritate your lungs if you are exposed to them. An additional safety measure you can take to prevent this will be to put on a nose mask. Ensure that your nose mask isn’t hindering your breathing in any way.
It would be best if you didn’t attempt to hold your PVC pipe down with your bare hands. It can slip from your hands. You can injure yourself, or make a very jagged cut on the pipe. It would be best if you got a clamp that will hold the pipe down while you cut it
It would be best if you lubricated your PVC pipe properly before attempting to cut it. What most people don’t understand is that lubrication keeps friction away when they are cutting their pipes. If you don’t lubricate your pipe, it will be hard for you to cut through it, and it will take longer than it should. It would be best if you also were careful with whichever lubricant you will be using on the pipe. Some lubricants eat your pipe after a long time
You can use cooking oil as a lubricant or a silicone-based lubricant. Silicon-based lubricants are made from rubber and plastic, and they are sage for your pipe
When you have changed down your pipe and are sure that it has been appropriately lubricated, you can go in with your handsaw. It would help if you didn’t go too fast with it as it might be challenging to concentrate on it, and you risk cutting yourself. Go slowly at first in a back and forth motion, and when you are sure you have gotten the hang of it, you can then go faster with the handsaw.
When you are done cutting your pipe, you will notice burrs. The burrs are usually rough and jagged. To smooth this out, you can get a kitchen knife and scrape it until it is even. You can also use sandpaper to rub at it until the end of the PVC pipe has been evened out and is smooth.
Conclusion
A handsaw for cutting PVC pipe is ideal in a situation where the project to be done with the pipe isn’t cumbersome. Hand saws are cheap and are also easy to get.
You may also read....